The Thermo Scientific Thermolyne Benchtop Muffle Furnace is ideal for general laboratory use, including gravimetric analysis, sintering, quantitative analysis and heat treating. It reaches a 1200°C maximum temperature and is available in two capacities for added flexibility. The built-in vent port removes contaminants and moisture to extend the life of the heating element and furnace.

• Includes the D1 Digital Controller
• Programmable with four (4) stored program of sixteen (16) segments
• Each segment includes one ramp and one dwell, so you can create four programs with 16 ramp/dwell cycles.
• The ramp is used to vary the heat-up rate to your specified setpoint. The furnace will then dwell (hold the temperature) at a set level for a specified time.
• An LED display simultaneously shows both setpoint and actual furnace temperatures.
• Includes a mechanical overtemperature protection relay
• RS-232 communications interface also included.
• Includes ceramic shelf (SH480X1) that doubles furnace load capacity
• For added protection, the door safety switch stops power to heating elements when door opens
• Thermocouple break protection cuts power to heating elements, preventing a thermocouple failure runaway condition
• Two open coil heating elements on chamber sides assure fast heat-up with minimum temperature gradient
• Thermal-efficient ceramic insulation surrounds chamber for maximum energy efficiency
• Includes a 0.38-inch diameter port for monitoring chamber temperatures with independent measuring device at rear of chamber
• Includes Power Cord

Standard Lead Time: 10 Days